NEWS

NEWS

News

Jul 28,2022

The advantages of using pneumatic tools

Advantages and advantages of the use of pneumatic tools Air is a non-polluting energy source and easy to use

The advantages of using pneumatic tools

Jan 10,2022

Standard for the safe use of pneumatic tools

Before using pneumatic tools, pay attention to the pressure requirements of pneumatic tools, not too large, not too small; Confirm the intake joint, and the gas pipe will start to work properly after it is locked

Standard for the safe use of pneumatic tools

Nov 12,2021

How to choose the right pneumatic tools

At present, more and more factories need to use air opening tools, like sheet metal factories use more sanders and grinders, mainly used for trimming and polishing surface, and will use grinding pieces on a larger level, and some painting factories will use spray painting and blowing dust, the same pneumatic sander and pneumatic screwdriver will also be used. There are also some shipyards and auto parts factories will use pneumatic wrenches and pneumatic screwdrivers, etc., here will not be introduced one by one.

How to choose the right pneumatic tools

Nov 12,2021

Avoid injury with tool technology that reduces reaction forces

Ergonomics or tool control? Until recently, it was a matter of "one or the other". Manufacturers generally agree that power tools that reduce reaction forces do not provide the torque control they need. Today, however, assembly tools using reaction reduction technology are highly accurate, easy to integrate, and more ergonomic than ever before.

Avoid injury with tool technology that reduces reaction forces

Nov 12,2021

Working principle of power ratchet wrench

Power ratchet wrenches (whether pneumatic or rechargeable) work in a very similar way. They usually have a high speed motor that turns in the same direction whenever the nut is tightened or loosened. The motor drives the output through planetary gears, which reduces speed and increases torque, with gear ratios typically between 4:1 and 6:1. The output of the gear unit drives a crankshaft with an offset pin at the end. The offset pin swings a yoke, which is restricted to move only from one side to the other. With this arrangement, a full turn of the crankshaft will swing the yoke from side to side and back again. You can imagine the operation of a manual ratchet wrench, as you repeatedly swing the handle back and forth, the yoke is doing the same thing, only with a shorter angular stroke and much faster speed.

Working principle of power ratchet wrench

Nov 09,2021

Quality assurance is a necessary condition for the long-term development of pneumatic tools

With the development and continuous application of science and technology, the competition in the pneumatic tool industry is becoming more and more fierce.

Quality assurance is a necessary condition for the long-term development of pneumatic tools
< 1234 >